The Auto Channel
The Largest Independent Automotive Research Resource
The Largest Independent Automotive Research Resource
Official Website of the New Car Buyer

Why Grade 70 Is the Standard Transport Chain for Flatbed Securement


PHOTO (select to view enlarged photo)


Flatbed haulers deal with massive dynamic stress every single mile. When an open-deck trailer carries steel coils, structural beams, or heavy machinery, static weight becomes an active physical force the second the driver steps on the brakes or takes a sharp bend. Securing these payloads demands reliable hardware, and professional drivers rely heavily on durable heavy-duty truck parts to keep their loads locked down tight.

Choosing the correct tie-down gear from heavy-duty truck parts isn't just about grabbing the thickest metal link in the toolbox. It comes down to strict transport standards set by regulatory agencies and material engineering. Among all available options-ranging from low-grade proof coil to high-tensile alloy links-Grade 70 transport chain remains the universal standard across the commercial flatbed industry.

Lytx's 2024 guide to DOT load securement shows that the rules run on arithmetic. The working load limits of all tiedowns together must reach at least half the cargo's weight, and wheeled or tracked equipment over 10,000 pounds needs four direct tiedowns with tightening devices. Every chain in that sum needs a manufacturer-set working load limit, which is the practical reason a marked Grade 70 chain is the default on a flatbed.


Metallurgical Rating and Strength-to-Weight Efficiency

Chain grades indicate tensile strength per unit of cross-sectional area. Grade 30 proof coil works well for general utility tasks but is forbidden for heavy tie-down operations.

Grade 43 high-test chain in heavy duty truck parts handles farm or towing tasks, but it lacks the strength required for severe commercial payloads.

Grade 70 chain uses heat-treated carbon steel engineered specifically for cargo transport. It delivers an optimal balance: higher strength than standard carbon steel without the extreme cost or brittle tendencies of specialized lifting alloys. Grade 80 and Grade 100 alloys are meant for overhead crane lifting because they stretch under extreme dynamic impact before breaking. Transport tie-downs, however, require high yield strength that prevents stretch altogether during road transit.


Heavy Duty Truck Parts: The Arithmetic Behind DOT Requirements

Federal cargo securement rules leave zero room for guessing. The aggregate Working Load Limit (WLL) of all tie-downs combined must equal at least 50% of the weight of the cargo being secured.


PHOTO (select to view enlarged photo)
Click CHART to enlarge

A standard 3/8-inch Grade 70 chain offers a 6,600 lb WLL. Four direct tie-downs easily surpass the legal minimum for heavy machinery while keeping the equipment lightweight enough for a driver to throw across a deck manually without physical fatigue.


Roadside Inspections and Identification

DOT inspectors check physical markings on every tie-down system during scales and roadside stops. If a chain lacks visible grade stamps, inspectors default to rating it as Grade 30 proof coil. That rating drop immediately slashes the aggregate WLL calculation, resulting in out-of-service violations.

Grade 70 transport chain in heavy-duty truck parts features permanent embossing-such as “G7,” “7,” or “70”-stamped into the links at standard intervals. Its signature gold-zinc or yellow-chromate finish also gives inspectors immediate visual confirmation while offering corrosion resistance against harsh winter road treatments. Combined with forged ratchet load binders, Grade 70 chain provides clean compliance and dependable, calm control on every haul.