Online catalog of 60,000+ auto parts, engine parts, service parts and repair parts for domestic and import automobiles at wholesale price. Including Electrical Parts, Electrical Wiring, Climate Control, carburetors, Clutches, Cooling Systems, Drive Belts, Driveshaft, Axle, Power Steering Pump, Water Pumps, Suspensions, Transmission Parts, Cam Followers, Fuel Injectors, Fuel Filters, Brake Pads, Rotors and other. The majority of auto parts featured here are original equipment (OE) manufacturer parts and some aftermarket parts. Our 60,000+ auto parts are ready for immediate ship! Up To 70% Off Dealer Price!
Honda Spark Plugs, Igniter, Coil, Distributor, Rotor | Bosch, NGK, Denso, Champion @ The Auto Channel
Ignition Conversion Kit
Crane/Allison Fits Models W/ Point & Condenser Type Dist.
Universal (Any Model)
This kit is used to replace conventional points & condenser type ignition. Fits most 4,6 & 8 cylinder vehicles with negative or positive ground. All parts required,less trigger & module. Installation Kit part 700-2231.
BKR6E-11 NGK, use 6 of NGK BKR6E-11
1997 Honda Passport 3.2 V6 4WD (Engine: 6VD1)
If using Bosch spark plugs for this application, note that Bosch recommends using only #4417 (Platinum+4), 4303 (Platinum2), 4202 (Platinum), or 7557 (Super).
Remanufactured gear-reduction starter for Calif. model
1991 Honda CRX 1.5 HF (Engine: D15B6)
If installing a Bosch reman. starter for this application, note that Bosch may supply a Mitsuba or Nippondenso-style starter. The two starters may differ in appearance, but Bosch advises that either style starter will perform properly when used on this application.
Remanufactured for models with Mitsuba starter
1985 Honda Accent 1.6L DOHC-16V (Engine: G4ED)
If installing a Bosch reman. starter for this application, note that Bosch may supply a Mitsuba or Denso-style starter. The two starters may differ in appearance, but Bosch advises that either style starter will perform properly when used on this application.
for non-Calif, model
1996 Honda Prelude 2.2 Si V-TEC (Engine: H22A1)
When installing this new-design igniter, either heat sink #30121-PT2-006 (Accord & Prelude models) or #30121-PM5-A02 (Civic and Integra models) is also required for proper installation, but is not included with the igniter. Order the the correct heat sink separately as needed.